Description

🛠️ Easy Installation – Video Below!

This aluminum sandwich plate makes it simple to install your Oil Pressure and Oil Temperature senders—no drilling or tapping required. Just:

Remove your oil filter.
Screw the plate on in its place.
Reinstall the filter on top of the plate.
Install your senders into the available ports.

The plate includes (4) 1/8" NPT fittings, 4 plugs, an O-ring gasket, and installation instructions. It can rotate 360° to help you find the ideal orientation for sender clearance.

⚠️ Fitment & Notes

If unsure about sizing, please call or email us.
Designed for 2.6–3.15 in (66–80 mm) diameter spin-on oil filters only.
Plate adds 29mm (1.15") to your oil filter length—check clearance, especially on vehicles like the WRX, which may require heat shield modification.

🔩 Center Nut Torque Specs

Torque: 23 ft-lbs
Nut Size: 26mm (1")

📋 Size Options & Vehicle Compatibility

Here are baseline fitment suggestions. For exact compatibility, please call us Mon–Fri, 9 AM–5 PM EST.

🔧 M20 x 1.5

Subaru
Non-metric Honda
Mitsubishi, Acura
Hyundai
Nissan Sentra 2.5L, 350Z
Mazda RX-7, RX-8
Porsche
Honda S2000

*Note: Some modification may be required for 2006–2007 WRX TR edition. Consider our Remote Oil Pressure Kit as an alternative.

🔧 M22 x 1.5

Mazda 6 (V6)
Ford 6.8L Super Duty, 4.0L Mustang, Explorer, Sport Trac
Mustang GT 4.6L, F-Series 5.4L
Metric Honda Civic/CRX
Some Metric Chevy and Ford models

🔧 3/4 UNF-16

Mazda (with spin-on conversion)
Nissan, VW, Ford, BMW
Scion, SRT-4, SR20, Toyota, Jeep
Compare Long Shaft Version ›

🔧 3/4 UNF-16 – Long Shaft

Toyota Celica
Scion tC, MR2
Lexus IS300 (2JZ-GE)

🔧 13/16 UNF-16

Most early Chevy 4/6/8 cyl. (305, 5.0, 5.7)
Some Buick, Pontiac, Oldsmobile
Does not fit big blocks or Gen 1 350.

🔧 M18 x 1.5

Some Pontiac and Chevy 5.7L

🔧 Sensor Installation Tips

NPT threads are tapered—tighten by hand, then turn 3/4 to 1.5 turns more.
Some exposed threads are normal and necessary for sealing.
Use Teflon tape or Loctite on the threads for a proper seal.
Do not overtighten or you may damage the threads.

📹 Installation Video